KEECA25-192 Torsion Spring for Keencut Excalibur 5000

Replacement torsion spring for the Keencut Excalibur 5000 sheet material cutter

How to replace the cutting head return spring on the Excalibur 5000:

No tools required.

1) Remove the old spring by unlatching the outer leg of the spring from its groove on the cutter head casting.

2) Rotate the spring coil on its plastic mandrel until the other shorter leg of the spring comes free.

3) Pull the coil free from its mandrel.

4) Insert the short leg of the spring into the gap between the black casting and the carriage and feed the coil onto its plastic boss so that the long leg of the spring is pointing vertically up.

5) Rotate the leg leg clockwise when viewed from the left and latch it under the groove in the casting on the edge of the raised circular upstand.

See also:

4529 Keencut Excalibur 5000