10592 GlüBot Glue Bottle 473ml

GlüBot is the only glue bottle that is always ready and will not drip or spill

The easy-squeeze bottle features a unique two-chamber design that sucks the glue back when squeeze is released which eliminates dripping. Glue level remains high at the tip even when the bottle is running low. GlüBot will put as much or as little glue just where you want it.

The GlüBot is good for careful placing of glue and is perfect for applying glue to the mitre cut ends of wider mouldings.

GlüBot features:

+ Holds 473ml / 16oz of glue. Bots are supplied ready to fill.

+ Bottle size: 160mm tall, 55mm dia

+ Tips are 30mm long and 18mm dia 

+ Will not drip or spill

+ Easy grip and balance for busy working

+ Wide mouth for easy filling

GlüBot pack contains:

1 x GlüBot Glue Bottle with screw-on caps and red tip cover

1 x Pointed Clear Glue Tip

1 x Blade Clear Glue Tip

1 x Panel Edge Guide for Blade Tip

GlüBot is quick to set-up:

Remove the large fill cap and pour in as much glue as you wish and replace cap. Squeeze until the narrow tube on the side is full of glue. 

Take red cover off the clear tip and park it on the oval peg in the fill cap. Cut end of clear glue tip, a little bit at a time. Check that the fill cap and the tip cap are tight then the GlüBot ready for use. 

Place the tip where glue is needed. Squeeze gently and as soon as you stop, any drip is sucked back, so nothing is wasted, and it’s ready to go next time. When stopping work, always replace the cap on the clear tip. Clean up with water.

Take care to keep the fill cap and the tip cap clean and the black seals in place.

FastCap ref: 003 49 802

See also:

10579 BabeBot Glue Bottle 118ml / 4oz 

3000C LION D3 PVA Wood Adhesive 5L