This product is no longer available.

3649 Cordless Shrink Wrapper Base Heater Unit

The Base Heater Unit has a mains voltage heating element inside with adjustable temperature control

When the Sealing Arm is placed into it, the arm heats up. Arm stays hot more than long enough to seal a pack both ways before it is placed back into the base unit. There it quickly re-heats.

The Sealing Arm is not connected to the base unit, so you can manoeuvre it any way you need. It allows you to apply clear shrink-film protection to frames, mounted prints and posters on board. 

Adjust the heating temperature to achieve a fine balance between sealing and cutting. It can take a little while to achieve this.

The Cordless Shrink Wrapper system requires a 240v, 5 amp supply. It is made in steel in UK, engineered to ISO 9002 and carries the CE mark. Some details of the design are copyright or subject of patent applications.

1125mm long. Made in UK

3649  Cordless Shrink Wrapper Base Heater Unit  1125mm long  spare

See also:

3450  Full Cordless Shrink Wrapper system, except roller base

3451  Rolls Dispenser 510mm / 20" wide, and takes film up to 762mm / 30"

Spares & accessories

3649  Base Heater Unit, takes both length arms spare

3452  Sealing Arm 610mm optional

3423  Silicone Foam Underlay

3837  Silicone grease for hot edge of Sealing Arms

The Cordless Shrink Wrapper System is designed for intermittent use only. 

Product information updated September 2020